Version 6

Published on 2017-12-13 in µGame.

The PCBs for version 6 arrived about a week ago, but I didn’t have time to work on it, between the day job and being sick. This evening I finally tested it properly:

The good things:

• moving the audio circuit was a good move, it’s now completely out of reach of fingers, and I think it also seems a bit louder when the LOS is not obscured by hands,

• using straight switch instead of angled one for reset also works well — I can have a hole in the case (if I have a case) for pressing it with a pin,

• straight buttons are easier to solder,

• adding a CS pin made the displays all work consistently,

• moving the LDO away from the buttons also made it easier to solder.

There are still some rough edges, though, that I only found out after actually testing a physical prototype.

The bad things:

• the CS pin uses a via, and touching that via with your fingers makes the display stop updating — I need to route that trace on front side entirely,

• the charging LED still shines whenever USB is connected, even if the battery is disconnected  — it does go off when the battery is fully charged, though,

So I scrapped the version 7 which was basically just a cleanup of version 6 ready for ordering a larger number of them, and prepared version 8. I moved practically all parts around, including the microcontroller and the flash chip, but now:

• the reset button is next to the direction buttons, not on the edge of the pcb,

• all components, except for the audio circuit, are together in the middle of the board,

• the signals for audio and for the display are routed on one side without any vias,

• there are no parts under the fingers anymore,

• the top fire button got moved to the edge to make room for the parts, so now the layout looks more like gameboy,

• all the parts are better spaced and have shorter traces between them,

• there are more mounting holes (some are under the display, but with flat heads that could still be useful),

• I have broken out four unused pins on the back, for possible hacking,

• I moved the battery connector to the other side of the board, so it now matches the layout of Nokia phone (dumb) batteries.

I know I said that about the previous version, but this is really to be the last one I’m making (at least with this microcontroller and display) — if everything works, that is. I’m going to order this one at Aisler again, to see how they improved (and to get a stencil).